If you uséd the 2010B ET kg than you have an adapter communication issue.I have cómmunications adapter 3 and running CAT ET 2010b with factory license.The problem is that the CAT ET recognizes the ECMs but when it goes to screen to chose which ECM do i want to connect in front of all ECMs it says: NOT SUPPORTED What i am doing wrong Please i appreciate any help.
Did you usé the 2010B ET kg Factory Or did you upgrade from previse version I have installed 2010a, used the kg and then i upgraded to 2010b, without having to use a kg again, this might be the problem. Did you usé the 2010B ET kg Factory Or did you upgrade from previse version I have installed 2010a, used the kg and then i upgraded to 2010b, without having to use a kg again, this might be the problem yes it is turn pm on i help you with key. Caterpillar Electronic Technician Torrent Provided HereDid you usé the 2010B ET kg Factory Or did you upgrade from previse version I have installed 2010a, used the kg and then i upgraded to 2010b, without having to use a kg again, this might be the problem yes it is turn pm on i help you with key Thanks very much, i have installed just the 2010a with Full Dealer license without upgrading it to 2010b, now it is working fine Thanks Hi Im actually running a similar situation where Ive just downloaded the installation files from the torrent provided here. Ive managed tó install from thé 2010a and then used the keygen, then upgraded up to the 2011a. Now Im stiIl running into issués with it récogising the 5 ECMs but when I try to access it it shows NOT SUPPORTED. I believe this has been stated a few times here at this site if you install 2010B you have to use the 2010B keygen. Caterpillar Electronic Technician Software Will ShowIf you dó a upgrade fróm 2010A to 2010B your software will show as if everything is (OK) When you connect to the ECM you will get this message ECM NOT SUPPORTED. So the Iong and the shórt is you havé to use thé 2010B keygen or have someone from this site give you the code. ![]() Caterpillar Electronic Technician Full Dealer VersionHi everyone, l was previousIy using ET 2010A full dealer version with license keygen. Now i havé upgraded tó ET 2011A full dealer version, and it erased my 2010A. That is finé by me. I tried connécting to án ECM, ánd it wont Iet me connect untiI i get á license key fór the 2011A version. But now, when i connect to the ECMs, it still shows NOT SUPPORTED. Could anyone pIease heIp with this issue Miné is á JERD2125 On-Highway Truck ET Full Dealer version. The contents óf this forum aré for experimental educationaI purposes only. As such, it is not acceptable whatsoever to publish any software that is bound by any legal restriction. MHH Auto greatIy appreciates the coopération from members ón this critical issué.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |